3005-403-4-00

SEW MOVITRAC Frequency Inverter English Detailed Specification

1. Model Code Definition

2. Electrical Technical Parameters

• Rated Power: 15 kW

• Input Voltage: 3-phase AC 200~240 V (Nominal 230 V)

• Input Frequency: 50 Hz / 60 Hz

• Rated Output Current: 58.0 A

• Output Voltage: 0~230 V three-phase AC

• Output Frequency Range: 0~400 Hz

• Control Mode: V/F open-loop control

• Overload Capacity: 150% rated current for 60 seconds

• Carrier frequency: Adjustable

3. Physical & Environmental Parameters

• Protection Class: IP20

• Cooling Mode: Built-in fan forced air cooling

• Operating Temperature: 0 °C ~ +45 °C

• Storage Temperature: -25 °C ~ +70 °C

• Working Humidity: 5%~95%, non-condensing

• Installation Mode: Vertical wall mounting

• Application altitude: ≤1000m without power derating

4. Standard External Interfaces

• Onboard RS485 communication interface

• Multi-channel digital input / relay signal output terminals

• 0-10V analog speed regulating input interface

• Multi-segment fixed speed control terminal

• External motor overheating protection access port

5. Main Operating Functions

• Acceleration and deceleration time adjustable freely

• Built-in dynamic braking unit for fast stop

• Intelligent energy-saving operation mode

• Support keyboard local control, terminal control and remote communication control

• Speed slip compensation function to stabilize running speed

• Soft start & soft stop reduce mechanical impact

• Automatic voltage stabilization function

6. Full-range Protection Functions

• Overcurrent protection

• Overvoltage & undervoltage protection

• Input phase loss protection

• Inverter over temperature protection

• Motor overload electronic thermal protection

• Output short circuit protection

• Ground fault protection

• Running stall prevention protection

7. Installation and Wiring Rules

1. Cut off all power supply before wiring and maintenance

2. Power cables and control cables must be laid separately

3. Must connect reliable PE protective grounding wire

4. Reserve enough ventilation space around for heat dissipation

5. Avoid dusty, humid, oil mist and strong vibration installation environment

6. It is recommended to use shielded special motor cables for output lines

8. Commissioning Operation Steps

1. Check all wiring to confirm no wrong wiring and short circuit

2. Confirm that the input power supply voltage is consistent with the inverter specification

3. Set motor rated voltage, rated current, upper and lower limit frequency parameters

4. Select the corresponding control mode according to on-site requirements

5. First perform no-load trial operation to check operating sound and status

6. After confirming normal operation, gradually load for formal use

9. Daily Maintenance Items

• Regularly clean cooling fan and internal dust

• Regularly check whether each terminal is loose

• Real-time monitor operating current and internal temperature

• Timely replace aging and damaged cooling fans

• Fault inspection and maintenance must be operated by professional electricians

10. Main Application Scope

11. Compliance Certification Standards